THE "EAGLE CLAW" OF BEARING EXTRACTORS
THE EXTENSION TUBE AVAILABLE ALLOWS EXTRA REACH OVER LONG SHAFTS
THE ONLY SOLUTION WHEN NO OTHER EXTRACTOR CAN GRAB HOLD OF THE BEARING SURFACE
THE 242 MASTER KIT IS COMPRISED OF OVER 13 COMPONENTS

M0002  -Extractor Tip needed for pulling chain tensioners. Used in conjunction with a slide hammer.
Applicable: Mercedes engine - M110.

M0008  -Chain Tensioner (Rigid), needed for the proper R&R of cam shaft and its housing while checking and adjusting cam shaft timing.
Applicable: Mercedes engine - M110.

M0003  -Seal Guide
Needed to prevent damage to the seal during installation of timing cover with seal already in place.
Applicable: Mercedes engine - M104, M103 3/’89+.

M0004  -Seal Guide
Needed to prevent damage to the seal during installation of timing cover with seal already in place.
Applicable: Mercedes engine - M103 2/’89-.

M0083  -Pair of pins, needed for the proper alignment of cam shafts during R&R.

Applicable: Engine M111, M119 

M0049  -Impact Type Rail Pin Puller comes complete with a set of 5 Extractor Pins and its own easy to hold, hand-sized slide hammer.
Comes with extractor pin sizes:6X50mm / 6X150mm / 8X150mm / 10X100mm
6X100mm.

M0044  -Rail Pin Puller Guide (Overall Length of 85mm), designed with a thrust bearing to ease the pulling action. Needed for the proper extraction of rail pins from cylinder head. Especially useful in restricted spaces where other pullers and slide hammers won’t fit. Comes equipped with a 6mm extractor pin. Applicable: Mercedes engine - M102, M110, M115, M116, M117, M130, OM601, OM602, OM603, OM615, OM616, OM617.

M0001  - Sliding Puller Guide needed for the proper extraction of rail pins from cylinder head. Comes equipped with a 5mm and 6mm extractor pin. Compare this Sliding Puller Guide with Rail Pin Puller Guide# M0044. Applicable: Mercedes models

M0026  - Pin Wrench Socket with 1/2" drive, needed for R&R of grooved nut on drive pinion shaft flange of differential. Applicable: Mercedes chassis - W107, W114, W115, W116, W123, W126. Models with constant velocity joint axles.

M0027  - Pin Wrench Socket with 1/2" drive, needed for R&R of grooved nut on rear axle shaft flange, necessary when replacing axle bearing or seal. Applicable: Mercedes chassis - W107, W114, W115, W116, W123, W126. Models with constant velocity joint axles. 

M0028  - Pin Wrench Socket with 1/2" drive, needed for R&R of grooved nut on front differential counter shaft. Applicable: Mercedes Transmission - G76/18, G76/18A, G76/18C, G76/27, G76/27A, G76/27-5.

M0029  - Pin Wrench Socket with 1/2" drive, needed for R&R of grooved nut on transmission drive shaft flange. Applicable: Mercedes transmission - K4A 025.

M0030  - Pin Wrench Socket with 1/2" drive, needed for R&R of grooved nut on drive pinion shaft flange of differential. Applicable: Mercedes swing axle types.

M0032  - Pin Wrench Socket with 1/2" drive, needed for R&R of grooved nut on transmission drive shaft flange. Applicable: Mercedes transmission - K4C 025, W4B 025, K4A 040.

1089  - Designed to extract bearings and bushings with an I.D of 15mm and up to 20mm
For Bearing use only!!
Not Bushings.
Applicable:
Most Foreign and Domestic mid-to full size vehicles.