BMW 3040 Exclusively designed to properly secure and align the cam and crank shaft during R&R of cylinder head assemblies of BMW V8 engines.
This Sir Tools special service tool even comes equipped with the crucial T.D.C. Pin needed for setting the crank shaft. Cam Master Kit applicable: BMW engines - M60, M62, M62TU. T.D.C.  

BMW 3008 Holder for securing water pump hub
from rotating during R&R of fan clutch nut.
APPLICABLE M10, M20, M30, M50, WITH 32MM CLUTCH NUT.

BMW 3037
Holder USED for securing water pump hub
from rotating during R&R of fan clutch nut. 
Applicable: Engine - M40, M41, M42, M60, M62 

1032x36T
32 x 36mm Thin Wrench
with an 8mm overall thickness
and an overall length of 12 inches for proper leverage.
Used for proper R & R of fan clutch nut.
Many other applications for this Tool.

BMW 3034 Set of Three Tools.
For securing the crank shaft pulley from rotating
during R&R of center crank bolt.
Over 2 foot long leverage bars. Applicable:
Engine - M60, M62, M70, M73; M20, M42, M44, M50, M52; M30; Chassis - E30.

BMW 3034-1 Bolts specifically up to the pulley face
while the arm rests on the chassis
during R&R of crank bolt.
Applicable: Engine - M60, M62, M70, M73.

BMW 3034-2 Bolts specifically up to the pulley face
while the arm rests on the chassis during R&R of crank bolt.
Applicable: Engine - M20, M42, M44, M50, M52.

BMW 3034-3 Bolts specifically up to the pulley face
while the arm rests on the chassis during R&R of crank bolt.
Applicable: Engine M30

BMW 3031 Used for R & R of slotted nut on cylinder tube on steering rack.
Important when replacing steering rack seals.
Applicable Chassis E30

BMW 3018 Arbor needed for the proper installation of oil seal
on pulley side of crank shaft.
Applicable: BMW M20.

BMW 3020 Arbor needed for the proper installation of radial oil seals
of gearbox output flange on Getrag gearboxes.
Applicable: BMW gearbox G242/262, G240/260.

BMW 3015 Engine Turning Bar used for adjusting valves and timing.
Applicable: BMW and 6 cyl engines with a single timing chain.

BMW 3016 Engine Turning Bar used for adjusting valves and timing.
Applicable: BMW with dual timing chains.

M 0050 Used for proper assembly of timing chain master link.
To be used in conjunction with tool M0050-A
or M0050-B

BMW 3009 Tank Adaptor used for pressurizing the liquid cooling system on models
with a "MALE"threaded filler neck on expansion tank.
Applicable: BMW models 3, 5, 6, 7 ‘87and newer.

BMW 3011 Tank Adaptor used for pressurizing the liquid cooling system.
For models with a "MALE" threaded filler neck on expansion tank.
Applicable: BMW models ‘88 and newer.