BMW 3035  - Aligns and holds camshaft in place when assembling timing chain.
Includes: Blocks and locking pin.
Set of three tools for the alignment and securing of camshafts.
Applicable: BMW Model M40, M43TU
For V-12 engines you must have 2 blocks and the locking pin for this procedure. 

BMW 3013  -SPRING LOADED
Valve Adjuster used for turning rocker eccentric in any position.
Applications include: BMW engine - M10, M20, M30.

BMW 3012  - Tappet Depressor used for preloading cam followers
when exchanging valve adjusting shims.
Applicable: BMW M engines Excluding European models. 

9710  - Used for T.D.C. on any Gas engine.
Simply unscrew a spark plug and twist the rubber hose
part of this tool into the spark plug hole.
As you rotate the engine with a turning bar,
the piston forces air through the whistle part of this tool.
Once the whistling stops the engine is at T.D.C.

BMW 3022 - Five Sided Driver (Pentagon)
Needed for R&R of BMW antitheft radios. Applicable: BMW models equipped with an antitheft radio mount.

10-218A  - Valve Stem Seal Plier used for the proper extraction of stem seals.
The inside grooves on the tips of this Plier allows the firm grip
of both O.E. and aftermarket seals
Applicable: Most Overhead Cam engines. 

10-208 Shim Plier is used for proper R&R of valve adjusting shims. 
Applicable: Overhead Cam engines with adjusting shims.

1018 Pressure Adaptor 
needed for pressuring the master cylinder or clutch slave cylinder reservoirs.
Used in conjunction with a pressure bleeder.
Comes with a 1/4-18 NPT threaded opening. Applicable:
Most European models.

4491B Special 22mm Crowsfoot Socket with 3/8 Drive
Used for the removal and replacement of Oxygen Sensor that are situated within a confined area.
No need to snip the wires leading to the unit when all you want to do is check the sensor. Applicable: Most European Models.

BMW 3004 Clutch Wear Gauge used for checking thickness of clutch disk
without removing the transmission. Applicable: BMW models ‘75 and newer. 

12- 15mm
Universal Pilot Bearing and Blind Hole bushing Puller. 
Important: Removing the center bolt of this puller
will allow you to penetrate an I.D. as small as 12mm. 
Do not use on an I.D. larger than 15mm
Applicable: Most BMW and Asian and compact domestic. 
Excluding Suzuki and Geo

BMW 3036 - This new hand held pin wrench was designed to remove and install
the plastic shift coupler ring - nut, during R&R of of manual shift lever.
Made from Steel. Applicable: All BMW models ‘86 and newer.

Transmission Tool BMW 3025
Thin Wall Deep Socket Specially designed 30mm thin walled 12 point, deep socket needed for the proper R&R
BMW; transmission drive shaft flange nut and pinion drive shaft flange nut of differential.

BMW 3005 Wrench comes with a 10mm Allen insert,
and is used for the R&R of BMW Differential Oil Plugs
Applicable: All late model BMW's.

THE "EAGLE CLAW" OF BEARING EXTRACTORS
THE EXTENSION TUBE AVAILABLE ALLOWS EXTRA REACH OVER LONG SHAFTS
THE ONLY SOLUTION WHEN NO OTHER EXTRACTOR CAN GRAB HOLD OF THE BEARING SURFACE
THE 242 MASTER KIT IS COMPRISED OF OVER 13 COMPONENTS

1017 Heavy Duty Allen
17mm Stubby Socket
Heavy duty Allen socket designed specially for R&R of gearbox drain plugs.
For a variety of applications.